Maintenance - Husqvarna 350BT Operator's Manual

WARNING: Air is released when the
engine is started and when the product
is set at idle speed. Do not let persons to
come near the product or the blower
tube.
To operate the throttle control/stop
switch
B
C
D
• Apply full throttle (A).
• Apply 1/3 speed (B).
• Apply idle speed (C).
• Stop the product (D).
To operate the product
• Operate the product at usual work hours. Obey local
regulations.
• Decrease the pieces of equipment and select the
correct speed for your task. Use the throttle at lowest
position possible to prevent more noise and dust
than necessary.
• Keep the blower nozzle near the ground.
Note: Husqvarna recommends that you use the full
blower nozzle extension.
• Make a note of the wind direction and operate the
product in the direction of the wind.
• Use applicable garden tools to release material from
the ground.
• In areas with dust, use spray equipment to wet the
area. This decreases the operation time.
• After operation, keep the product in storage
vertically.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
1246 - 002 - 24.03.2020
A

Maintenance

To stop the product
CAUTION: Do not stop the product at full
speed.
1. Put the start/stop switch with throttle control in the
stop position. Refer to
stop switch on page 9 .
To adjust the harness
1. Put on the harness of the product.
2. Tighten the shoulder straps until the product is tight
against your body.
3. Put the waist belt around your waist.
4. Tighten the waist belt strap. Make sure that the
weight of the blower stays on your hips.
To operate the throttle control/
9