(Optional) Installation Of Waterproof Tape - 3xLogic VISIX S-Series Installation Manual

(OPTIONAL) INSTALLATION OF WATERPROOF TAPE

Purpose:
If the camera is installed outdoors, you can use the supplied water-proof tape to protect cable connectors and
unused cables after the camera is secured to the installation surface.
Steps:
1. Tear off the yellow release paper on the back of the water-proof tape.
2. Stretch the water-proof tape to reach twice the initial length.
3. Wrap the water-proof tape around the cable connector tightly as shown in the figure below.
12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
Installation Manual v3.1 | VISIX S-Series Network Camera
Align the snap and notch.
Camera
Water-proof Accessory Installation
Initial Length
Stretch
Waterproof Tape Length After Stretching
Stretch the Water-proof Tape
i. Insert into .
⑤ ④
ii. Secure with .
⑥ ④
Switch/Router
Stretch
32