Chapter 2. Setup; Unpacking; Setting Up The Gryphon™ Gd4200 Reader; Connect Host Interface - Datalogic Gryphon GD4200 Product Reference Manual

CHAPTER 2
SETUP

UNPACKING

Check carefully to ensure the scanner and any cables or accessories ordered are present
and undamaged. If any damage occurred during shipment, contact "
on page xiii
SETTING UP THE GRYPHON™ GD4200 READER
Follow the steps provided in this section to connect and get your reader up and commu-
nicating with its host:
1. Connect the Interface Cable to the reader as shown in Figure 2. To disconnect the
2. Connect the other end to the Host (see the next section, "
3. Modify "

CONNECT HOST INTERFACE

The scanner kit you ordered to match your interface should provide a compatible cable
for your installation. If this is not so, contact "
The scanner can communicate using the interfaces illustrated below.
For corded versions, connect the reader cable by inserting the cable into the handle as
shown in the following Figure.
To remove the interface cable from the reader, first locate the hole on the back of the
handle. Next, take a paper clip and modify it as shown in the figure below. Insert the
end of the paper clip into the hole and press it to push on the clip that holds the connec-
tor. As you apply pressure, pull out the cable.
When reinserting the cable, make sure the connector clip is on the same side as the
reader release hole. Insert the cable, it should click when it is fully inserted.
.
cable, insert a paper clip or similar object into the opening shown.
and Figure 3).
on page 5
Customizing Configuration Settings" on page 28
needed from factory settings).
NOTE: We recommend the use of a perfectly straight new paper clip to
make the operation easier (see the figure below).
Connect Host Interface"
(only if modifications are
Technical Support" on page xiii
PRODUCT REFERENCE GUIDE
Technical Support"
.
5