Ack Nak Timeout Value; Ack Nak Retry Count - Datalogic Gryphon GD4200 Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

ACK NAK Timeout Value

This option specifies the amount of time the scanner waits for an ACK character
from the host following label transmission. The selectable timeout range is 200
milliseconds to 15,000ms (15 seconds) in 200ms increments. A selection of 0
disables the timeout. See
programming instructions.
Select ACK NAK Timeout Value Setting
$CR2AT
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.

ACK NAK Retry Count

This feature specifies the number of times the scanner retries a label transmis-
sion due to a retry condition. The selectable range is from 1 to 254 retries. A
selection of 0 disables the count, and a selection of 255 specifies unlimited
retries. See
instructions.
Select ACK NAK Retry Count Setting
$CR2AR
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
44
GRYPHON™ I GD/GBT/GM4200
"
ACK NAK Timeout Value" on page 224
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
representing your desired character(s). End by scan-
ning the ENTER/EXIT bar code again.

01 ACK NAK Timeout value is 200ms
"
ACK NAK Retry Count" on page 225
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
representing your desired character(s). End by scan-
ning the ENTER/EXIT bar code again.

003 = 3 Retries
RS-232/USB-COM INTERFACES
for more detailed
Appendix D
CANCEL
for more detailed programming
Appendix D
CANCEL