Symbologies; Set Length; Set Length 1 - Datalogic Gryphon GD4200 Product Reference Manual

SYMBOLOGIES

Set Length

Length Control allows you to select either variable length decoding or fixed length
decoding for the specified symbology.
Variable Length:
be set.
Fixed Length:

Set Length 1

This feature specifies one of the bar code lengths for a given symbology. Length 1 is the
minimum label length if in Variable Length Mode, or the first fixed length if in Fixed
Length Mode.
Reference the Symbologies section on
characters) for the symbology being set.
Follow these instructions to set this feature:
1. Determine the desired character length. Pad the number with leading zeroes to
2. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
3. Scan the "Select Length 1 Setting" for the symbology being set.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the table below for examples of how to set this fea-
ture.
Table 24 Length 1 Setting Examples
STEP
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT LENGTH 1 SETTING for the desired symbology
Scan two characters from
4
Appendix D
5 Scan ENTER/EXIT PROGRAMMING MODE
For variable length decoding, a minimum and maximum length may
For fixed length decoding, two different lengths may be set.
yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
length setting which was determined in the steps above. You will hear a two-beep
indication after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION
to view the selectable range (number of
page 111
EXAMPLES
01 Character 07 Character 52 Character 74 Character
'0' and '1' '0' and '7'
SYMBOLOGIES
, that represent the
Appendix D
'5' and '2' '7' AND '4'
PRODUCT REFERENCE GUIDE
247