Disable Character; Enable Character - Datalogic Gryphon GD4200 Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Disable Character

Specifies the value of the RS-232 host command used to disable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
Character" on page 226
Select Disable Character Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.

Enable Character

Specifies the value of the RS-232 host command used to enable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
Character" on page 227
Select Enable Character Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
46
GRYPHON™ I GD/GBT/GM4200
for more detailed programming instructions.
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.

0x44 = Disable Character is 'D'
for more detailed programming instructions
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.

0x45 = Enable Character is 'E'
RS-232/USB-COM INTERFACES
"
Disable
$CR2DC
CANCEL
"
$CR2EC
CANCEL
Enable