Menu Communication; Write / Read Setup - Datafox PZE-MasterIV Basic Manual

Manual Datafox PZE-MasterIV Basic

4.5 Menu Communication

Note:
£ You can and should check all displayed communication parameters at each dialogue
that opens with one of the following function calls, and adjust them via the button
Settings if necessary.

4.5.1 Write / read setup

When the setup is finished, back-up it on disk via
setup you have to set the communication parameter for the device in question via
.
Einstellungen
¡
Caution:
Always check the communication parameter before transmitting the setup. This is
especially important when several devices are managed via the DatafoxStudioIV.
Pay particularly attention to the IP address of the device to which you want trans-
mit the setup.
Figure 34: Transmitting setup data
Likewise, a setup can be read out from the device in order to change it or to configure a second device
with the same setup. Open the corresponding dialogue via
a file name for the setup and check the communication settings. With OK you confirm all entries and the
setup is read out from the device.
Version: 04.01.07.00
Datei Speichern unter
¢ ¡
The device is only ready for operation with a com-
pletely transmitted setup. If the transmission is
aborted early, the device cannot be put into oper-
ation. In this case, a possibly existing disturbance
source has to be eliminated and the transmission
must be repeated.
Kommunikation
Page 48
. For transmitting the
¡
Kommunikation
¢ ¡
, give
Setup lesen
¢ ¡ ¡
www.datafox.de