Unitronics Vision OPLC V100-17-CAN Installation Manual

Vision™ OPLC™
This guide provides instructions for installing the CANbus communication module
(V100-17-CAN (CANbus) , V100-S-CAN (CANbus-Wide Temperature)
in a Vision130™ or Vision350™ or Vision430™ or SM35™ or SM43™ or SM70™ controller.

Danger Symbols

When any of the following symbols appear, read the associated information carefully.
Symbol Meaning
Danger
Warning
Caution Caution
Before using this product, the user must read and understand this document.
All examples and diagrams are intended to aid understanding, and do not guarantee operation.
Unitronics accepts no responsibility for actual use of this product based on these examples.
Please dispose of this product according to local and national standards and regulations.
Only qualified service personnel should open this device or carry out repairs.
Failure to comply with appropriate safety guidelines can cause severe injury or property
damage.
Do not attempt to use this device with parameters that exceed permissible levels.
To avoid damaging the system, do not connect/disconnect the device when power is on.

Environmental Considerations

Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration.
Do not place in water or let water leak onto the unit.
Do not allow debris to fall inside the unit during installation.

General

Turn off power before making communications connections.
Do not touch live wires
Unused pins should not be connected. Ignoring this directive may damage the device.
Double-check all wiring before turning on the power supply.

Installation Instructions

Before performing these actions, touch a grounded object to discharge any electrostatic
charge.
Avoid touching the PCB board directly. Hold the PCB board by its connectors.
Installing modules also requires you to remove and replace PCB boards already installed
in the controller.
Caution
Make certain that the pins fit correctly into their matching receptacle.
Unitronics
Installation Guide, CANbus Module V100-17-CAN,V100-S-CAN
Description
The identified danger causes physical and property damage.
The identified danger could cause physical and property damage.
Use caution.