Table of Contents
Advertisement
＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿
●
Do not damage, break or tamper
with the power cable. Do not place
a heavy object on the cable, pull, or
forcibly bend the cable to avoid the
risk of fire and electric shock.
●
Do not plug or unplug the power cable with wet hands
to avoid the risk of electric shock.
●
When unplugging the power cable, do not pull on the
cable but unplug by holding the plug.
Failure to do so may result in fire or electric shock.
●
When the machine is unused for a long period of time,
for example during holidays, unplug the power cable
from the power socket for safety reasons.
●
Remove the power plug from the power socket at least
once a year to clean the prongs and the area around the
plug. Dust collected in these areas can result in fire.
Grounding
●
Use a power plug with grounding wire or
a three-pin power plug (two-pole plug with
grounding wire) and ensure the plug is
properly grounded. When a plug with
grounding wire is used, ground the plug
before the power plug is inserted in the
power socket. Disconnect the grounding
wire after the power plug is removed from the power
socket.
●
If the machine is not grounded and a short circuit
occurs, this may result in a fire or electric shock.
Contact your dealer if you are unable to ground the
machine.
●
Never ground the machine to the following places to
avoid the risk of fire or electric shock.
•
Gas pipe
•
Grounding wire for telephones
•
Lightning conductor
•
Water pipe and water tap with plastic parts
●
Ground the machine to the following places.
•
Ground terminal in the power plug
•
Piece of copper that is buried 65cm or deeper in
the ground
•
Ground terminal with grounding work (type 1 to 3)
•
Water pipe which is approved by the water
department for grounding
Handling
●
Do not place water containers or metallic objects on
the machine. Fire or electric shock may occur if water
or metallic objects fall into the machine.
●
Do not use combustible spray or flammable solvent
near the machine.
If sprayed gas and flammable solvent contact
electronic components inside the machine, fire or
electric shock may occur.
●
Do not insert any metallic object or flammable
substance into the machine through any opening to
avoid the risk of fire or electric shock.
●
Do not remove machine covers to avoid the risk of
electric shock or injury.
●
Do not dismantle or remodel the machine to avoid fire,
electric shock or breakdown of the
machine. Ask your dealer to carry out
internal check, adjustment and repair
of the machine. Repair of a breakdown
due to dismantling or remodeling will be
fee chargeable even within the warranty period.
●
The thermal head and surrounding metal parts are hot
while the power is on, or just after the power is
switched off.
Do not touch it to avoid burning yourself.
When cleaning the machine, wait until it has cooled
down.
｜11｜
Preface
Advertisement
Table of Contents
Troubleshooting
