Summary of Contents for Panduit ATLONA AT-OME-RX11
Page 1
Omega 4K/UHD Scaler for HDBaseT and HDMI AT-OME-RX11 The Atlona AT-OME-RX11 is an HDBaseT receiver for video up to 4K/60 4:2:0, plus embedded audio, control, and Ethernet over distances up to 330 feet (100 meters). Part of the Omega™ Series of integration products for modern AV communications and collaboration, the OME-RX11 is HDCP 2.2 compliant and receives RS-232 and IP control signals.
Installation Guide AT-OME-RX11 Panel Descriptions AT-OME-RX11 LINK AT-OME-RX11 RX TX DC 24V RS-232 AUDIO OUT HDBaseT OUT HDMI IN RS-232 Connect an Ethernet cable to this port Bi-directional port for pass through to pass Ethernet to a local device from a display control from/to a compatible transmitter or from a local network switch transmitter.
Page 3
Installation Guide AT-OME-RX11 RS-232 A 3-pin captive screw connector has been included for RS-232. Pin out will be determined by the RS-232 cable and connect as RX (receive), TX (transmit) and (Ground). Audio Deembeds audio and sends to a connected audio DSP, amplifier, or other audio distribution devices.
Installation Guide AT-OME-RX11 Mounting Instructions The AT-OME-RX11 includes two mounting brackets and four mounting screws, which can be used to attach the units to any flat surface. Remove the top 2 case screws on the side of the unit. Align the mounting brackets to the side of the units. Use the previously removed case screws to secure the mounting bracket to the enclosure.
Installation Guide AT-OME-RX11 Cable Recommendation Guidelines Refer to the tables below for recommended cabling when using Altona products with HDBaseT. The green bars indicate the signal quality when using each type of cable. Higher-quality signals are represented by more bars. Core Shielding CAT5e...