Installing The Safety Chain; Product Overview; Controls - Toro CM-1258Y-SD Operator's Manual

2

Installing the Safety Chain

Parts needed for this procedure:
1 Safety chain
2 Connecting link
Installing the Safety Chain
1. Form a hook on the end of a bendable piece of rod
or stiff wire (not included), and insert it through both
keyholes in the front post of the machine
A
C
1. Keyhole
2. Rod or wire (not included)
2. Attach the safety chain to the length of rod or wire
(Figure 4A).
3. Pull the rod, or wire, and the safety chain through both
keyholes (Figure 4B).
Note: Ensure that approximately equal lengths of
safety chain extend from either side of the front post.
Installing the Connecting Links
1. Align the connecting link to the last link in one end of
the safety chain (Figure
2. Insert the connecting link through the chain link until
the connecting link snaps closed.
3. Repeat steps 1 and
in the other end of the safety chain.
(Figure
B
1
2
3
D
4
3
Figure 4
3. Safety chain
4. Connecting link
4D).
2 to install the other connecting link

Product Overview

4A).
1. Engine cowl
2. Drum
3. Handwheel
4. Safety-chain keyholes

Controls

g019883
Become familiar with all of the controls before you start the
engine and operate the machine.
Handwheel
The handwheel controls the tilt of the drum.
Drum-Tilt Brake
The drum-tilt brake locks the drum into position.
9
Figure 5
5. Tow pole
6. Drum-tilt brake
7. Rubber latch