Toro CM-1258Y-SD Operator's Manual page 14

1 3
4 2
Hitching a Machine with a Stamped Ball
Coupler
1. Apply chassis grease to the socket of the coupler and
the area of the clamp that contacts the ball.
2. Oil the pivot points and sliding surfaces of the coupler
with SAE 30 motor oil.
3. Open the coupler latch
Figure 14
(Figure 15).
A
G021 107
B
1
C
1. Bail
4. Position the coupler on top of the hitch ball
15A).
5. Close the coupler latch
6. Open the bail on the safety pin and insert the pin
through the hole in the latch
7. Rotate the free end of the bail over the end of the safety
pin that is protruding through the latch
8. If the machine is equipped with a trailer-light kit,
connect the wire plug of the tow vehicle to the wire
plug of the machine.
14
2
G020359
Figure 15
2. Safety pin
(Figure 15B).
(Figure 15B).
(Figure
(Figure
15C).