Storage; Storing The Machine - Toro CM-1258Y-SD Operator's Manual

Storage

Storing the Machine

Whenever you store the machine over 30 days, prepare it as
follows:
1. Clean the machine; refer to
32).
2. Start the engine. Allow the engine to idle for 3 minutes
and then stop the engine.
3. Drain the engine oil while the engine is still warm,
and fill the engine with new oil; refer to
Engine Oil (page 27).
4. Push the decompression lever down and hold it while
slowly pulling the recoil starter 2 or 3 times.
Note: Do not start the engine.
5. Drain the fuel tank by unscrewing fuel drain plug and
collecting fuel in a fuel container.
Note: Dispose of the fuel properly; recycle it
according to local codes.
6. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
7. Paint all scratched or bare metal surfaces with paint
available from your Authorized Service Dealer.
8. Store the machine in a clean, dry garage or storage area.
9. Cover the machine to protect it and keep it clean.
Cleaning the Machine (page
Changing the
33