Toro CM-1258Y-SD Operator's Manual page 4

•
Never let children or untrained people operate or service
the equipment. Local regulations may restrict the age of
the operator.
•
The owner/user can prevent and is responsible for
accidents or injuries to people or damage to property.
Towing
Check with your local county or state towing safety regulations
before towing the machine.
•
In order to reduce the possibility of an accident while
transporting the machine on public roads, make sure that
the towing vehicle is mechanically sound and in good
operating condition.
•
Shut down the engine before transporting the machine.
•
When towing with a ball hitch, ensure that the ball hitch
you are using is the proper size for the hitch coupler on
the machine.
•
When towing with a pintle hitch, ensure that the eye of
the tow pole is the correct dimension for the pintle hook.
•
Inspect the hitch and coupling for wear. Never tow the
machine with damaged or defective hitches, couplings,
chains, or other components.
•
Check the tire air pressure on the towing vehicle and the
machine.
•
Check the tire tread and sidewall for damage and wear.
•
Properly attach the safety chains to the towing vehicle.
•
Ensure that the directional and brake lights are working
properly (if the machine is equipped with the light kit).
•
Ensure that the directional, backup, and brake lights of
the tow vehicle are working properly (if the machine is
equipped with the light kit).
•
Before towing, check to make certain your machine is
correctly and securely attached to the towing vehicle.
•
Ensure that the safety chains are properly secured to the
vehicle, and leave enough slack for turning.
•
Do not carry any material in the machine when towing.
•
Avoid sudden stops and starts. This can cause skidding,
or jackknifing. Smooth, gradual starts and stops will
improve towing.
•
Avoid sharp turns to prevent rolling. Tow only with a
vehicle that has a hitch designed for towing. Do not
attach towed equipment except at the hitch point.
•
Do not tow the machine faster than 88 km/h (55 mph).
•
Use caution when backing up; use a spotter outside the
vehicle to guide you.
•
Do not allow anyone to sit or ride on the machine.
•
Disconnect the machine from the tow vehicle before
using it.
•
Place chock blocks underneath the tires to prevent them
from rolling while the machine is parked.
Preparation
Become familiar with the safe operation of the equipment,
operator controls, and safety signs.
•
Use only accessories and attachments approved by the
manufacturer.
•
Wear personal protective equipment and appropriate
clothing, including the following:
– Hard hat
– Respirator or dust mask
– Face shield
– Safety glasses
– Hearing protection
– Safety shoes
– Long pants
– Shirt with long sleeves that are tight at the wrists
– Tight-fitting gloves without drawstrings or loose cuffs
•
Secure long hair, loose clothing, or jewelry that may get
tangled in moving parts.
•
Operating the equipment safely requires the full attention
of the operator. Do not wear radio or music headphones
while operating the machine.
•
Use extra care when handling fuels. They are flammable
and the vapors are explosive. Use the following practices
when handling fuel:
– Use only an approved fuel container.
– Never remove the fuel cap or add fuel with the engine
running.
– Allow the engine to cool before refueling.
– Do not smoke.
– Never refuel or drain the machine indoors.
– Install the fuel cap and tighten it securely.
– Keep the container nozzle in contact with the tank
during filling.
– Never fill a container while it is inside a vehicle, trunk,
pick-up bed, or any surface other than the ground.
– Never store the machine or fuel container inside
where there is an open flame, such as near a water
heater or furnace.
– If fuel is spilled, wipe it off the engine and equipment.
•
Ensure that the machine is on a level surface before
operating the machine.
•
Chock the tires of the machine to prevent unintended
movement.
•
Before every use, do the following:
– Inspect the coupler, ball, and hitch.
– Ensure that all lights are functioning properly (if the
machine is equipped with a light kit).
– Ensure that the tires are properly inflated as
recommended.
4