Toro CM-1258Y-SD Operator's Manual page 21

Figure 26
1. Engine-speed-control knob
4. Rotate the engine-speed-control handle
counterclockwise to unlock it, pull it all the
way out, and lock it by rotating it clockwise
Figure 27
1. Engine-speed-control handle
5. Push the decompression lever to the left
Note: The decompression lever stays cocked to the
left and automatically returns to the original position
when the you pull the recoil-starter handle again.
1
(Figure
(Figure
6. Grasp the recoil-start handle, pull it out slowly until
you feel resistance, then pull it all the way out with a
strong and even motion
Note: Use 2 hands if necessary.
g020001
7. Slowly return the recoil-start handle to the initial
position.
27).
8. If the engine does not start, repeat steps
Stopping the Engine
1. Unlock the engine-speed-control handle by rotating
it counterclockwise, and push it in slightly, to the idle
setting.
2. Run the engine at low idle speed and without a load
for at least 5 minutes to allow engine components that
operate at a high temperature to cool down.
3. Push the engine-speed-control handle the rest of the
way in to stop engine.
4. Move the fuel-shutoff lever to the
after the engine stops.
Note: If the engine does not stop after you push the
engine-speed-control handle all the way in, stop the
engine by moving the fuel-shutoff lever to the
position.
6).
21
(Figure 28).
Figure 28
2 through 7.
position
CLOSED
g020367
CLOSED