Table of Contents
Advertisement
3. To remove the divider plate, lift it upward and rotate
it counterclockwise so that it clears various engine
components.
Installing the Divider Plate
1. Guide the divider plate into position against the front
cowl.
Note: Start with the divider plate rotated slightly
counterclockwise, and then rotate it clockwise while
lowering it into position.
Ensure that the divider plate is not backward.
Figure 30
2. Align the bolt holes in the divider plate and the front
cowl.
3. Install each of the 4 bolts, and hand-tighten them to
prevent cross-threading.
4. Tighten the bolts with a wrench until they are secure.
Lubrication
Lubricating the Machine
Service Interval: Monthly—Grease the trunnions and the
1. Clean around each grease fitting with a rag and lift the
plastic cap off the grease fitting
2. Use a grease gun to lubricate the grease fittings of both
trunnions and the drum spindle with general-purpose
lithium grease
3. Wipe up any excess grease.
G020753
Important: Do not lubricate the pinion gear and ring
gear. Lubrication will cause them to collect abrasive
materials and accelerate wear.
25
drum spindle.
(Figure
(Figure
31).
Figure 31
31).
g020000
Advertisement
Chapters
Table of Contents
