Changing The Engine Oil - Toro CM-1258Y-SD Operator's Manual

Concrete mixer
Hide thumbs Also See for CM-1258Y-SD:
Table of Contents

Advertisement

Changing the Engine Oil

Service Interval: After the first 25 hours-Change the
engine oil.
Every 100 hours-Change the engine oil.
Important: If the oil level in the crankcase is too low
or too high and you run the engine, you may damage
the engine. This type of damage is not covered by the
warranty.
o
o
o
-20
C -10
C
0
C 10
o
o
o
(32
F) (50
Draining the Engine Oil
WARNING
Oil may be hot after the engine has been run, and
contact with hot oil can cause severe personal injury.
Avoid contacting the hot engine oil when you drain
it.
1. Stop the engine and wait for all moving parts to stop.
2. Place a oil-drain pan under the oil-drain hole of the
engine
(Figure
35).
34.
SAE 20
SAE 30
SAE 40
o
o
o
C
20
C
30
C 40
o
o
F) (68
F) (86
F) (104
1
1. Oil-drain plug
2. Oil-drain hole
3. Remove the drain plug and catch the oil in the oil-drain
pan
(Figure
o
C
4. When the oil has drained completely, install the drain
plug with a new washer
g020376
Note: Dispose of the used oil at a certified recycling
center.
27
2
3
3. Oil-drain pan
35).
(Figure
35).
g020382

Advertisement

Table of Contents
loading

This manual is also suitable for:

68011

Table of Contents