Table of Contents
Advertisement
10.
Slide the outer foam element over the paper
element.
11.
Install the air cleaner elements and ensure that
they are properly positioned.
12.
Install the internal wing nut
13.
Securely install the cover with the other wing nut.
Changing the Engine Oil
Service Interval: After the first 25 hours—Change
the engine oil.
Every 100 hours—Change the engine oil.
Toro Premium Engine Oil is available from your
Authorized Toro Dealer.
Important:
Use 4-cycle engine oil that meets
or exceeds the following guidelines and
classifications:
•
API Service Categories CH-4, CI-4, CJ-4 or higher
•
ACEA Service Categories E-3, E-4, and E-5
•
JASO Service Category DH-1
Crankcase capacity: 1.6 L (1.7 US qt)
Important:
If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine. This type of damage is not
covered by the warranty.
Viscosity: Refer to
Figure
Figure 34
34.
Draining the Engine Oil
WARNING
Oil may be hot after the engine has been run,
and contact with hot oil can cause severe
personal injury.
Avoid contacting the hot engine oil when you
drain it.
1.
Stop the engine and wait for all moving parts to
stop.
2.
Place a oil-drain pan under the oil-drain hole of
the engine
1. Oil-drain plug
2. Oil-drain hole
g020376
3.
Remove the drain plug and catch the oil in the
oil-drain pan
4.
When the oil has drained completely, install the
drain plug with a new washer
Note:
Dispose of the used oil at a certified
recycling center.
30
(Figure
35).
Figure 35
3. Oil-drain pan
(Figure
35).
(Figure
g020382
35).
Advertisement
Table of Contents
