Table of Contents
Advertisement
Figure 29
3.
To remove the divider plate, lift it upward and
rotate it counterclockwise so that it clears
various engine components.
Installing the Divider Plate
1.
Guide the divider plate into position against the
front cowl.
Note:
Start with the divider plate rotated slightly
counterclockwise, and then rotate it clockwise
while lowering it into position.
Ensure that the divider plate is not backward.
Figure 30
2.
Align the bolt holes in the divider plate and the
front cowl.
3.
Install each of the 4 bolts, and hand-tighten
them to prevent cross-threading.
4.
Tighten the bolts with a wrench until they are
secure.
Lubrication
Lubricating the Machine
Service Interval: Monthly—Grease the trunnions and
1.
Clean around each grease fitting with a rag and
lift the plastic cap off the grease fitting
31).
2.
Use a grease gun to lubricate the grease fittings
g020752
of both trunnions and the drum spindle with
general-purpose lithium grease
3.
Wipe up any excess grease.
g020753
Important:
Do not lubricate the pinion gear and
ring gear. Lubrication will cause them to collect
abrasive materials and accelerate wear.
28
the drum spindle.
(Figure
Figure 31
(Figure
31).
g020000
Advertisement
Table of Contents
