Remote Control Operation - Argo MILO PLUS Operating Instructions Manual


The temperature cannot be adjusted.
This appliance automatically vaporises condensate in the cooling and heating mode.
When the air conditioner operates in cooling and heating mode, there is no need to drain condensate continuously; only
in certain weather conditions with very humid air may it occur that water deposits inside the unit. When its inner tank is
full, the air conditioner beeps 8 times and the message "H8" appears on the display to signal that the tank is full
and stop the appliance's operation.
Dehumidification
WARNING!
When using the air conditioner in dehumidification mode, always dispose continuous drainage, in order to maximise
dehumidification efficiency.
Use the drainage outlet on the appliance. The water can be drained into a drain by simply connecting a tube with 14
mm internal diameter (not supplied).
1. Remove the cap by turning it anti-
clockwise then remove the plug.
4. Avoid bends in the drainage tube.
FOR OPTIMAL OPERATION OF THE REMOTE CONTROL UNIT, ADDRESS THE
TRANSMITTER HEAD TO THE RECEIVER LOCATED ON THE AIR CONDITIONER.
To operate the remote control press the ON / OFF button on the handset. The icon on the remote
control display will flash once and you will hear a sound signal indicating that the signal has been
sent to the air conditioner.
In the off mode, the set temperature and the set timer will be displayed on the remote control.
V 06/20
HOW TO ELIMINATE CONDENSATE
Cooling and Heating
When the unit operates in the cooling and heating mode, ensure that the
rubber cap closing the drainage opening on the back of the appliance is
properly positioned.
To empty the container, switch the air conditioner off and unplug the cord.
Remove the cap from the rear drainage opening and place its end over a
normal drain. Ensure that the tube is not twisted or bent. The tube must
slope downwards. Re-close the drainage opening with the cap, insert it into
the clamp and resume use of the air conditioner.
2. Screw the connection tube
provided turning it clockwise.

REMOTE CONTROL OPERATION

3. Next, insert the drainage tube
into the connection tube.
43