Socket D750 Setup

Socket Mobile D750 Setup
Barcodes
After connecting the scanner to your device,
open an application. Put the cursor where you
want to enter data. Hold the scanner about 4
inches from the barcode and press and hold the
trigger button. Keep your hand steady and make
sure the red beam covers the entire width of the
barcode.
By default, the scanner will beep and vibrate, and the LED will flash
green to confirm that data was decoded and sent to the host device.
2. Simultaneous Scanning and Soft Keyboard Support
The Scanner supports simultaneous use of the barcode scanner and the
Apple iOS on-screen keyboard while entering data into an application.
To open or close the onscreen keyboard, quickly double press the power
button (like double-clicking a mouse).
After you double-press the power button, the scanner will beep to
indicate that the onscreen keyboard was enabled/disabled.
Watch a video:
1. Scanning
http://www.youtube.com/watch?v=VhtttoC6ROs
page 1 of 6
Phone 1 (800) 622-6484
Fax
info@choose2rent.com
www.choose2rent.com
1. Powering ON:
Press and hold down the small
power button until the LED turns
blue and the scanner beeps twice
2. Powering OFF:
Press and hold down
the small power
button until the
scanner beeps
twice.
Choose 2 Rent
1 (866) 937-8254