Advertisement
PIR LED Status
The PIR covers have two green status LEDs behind the PIR lens used for diagnostic purposes during commissioning or
servicing. The LEDs are used to indicate local movement detected by the PIR cover according to the following:
• The status LEDs will only start functioning to indicate movement 1 minute after the initial power up of the Room Controller
(24 Vac).
• The status LEDs will stop functioning to indicate movement 30 minutes after the initial power up of the Room Controller
(24 Vac).
LEDs location on PIR cover under the main sensor lens
Viconics Technologies Inc. | 7262 Marconi Street, Montreal, Quebec, Canada H2R 2Z5 | Tel: (514) 313-8885 | Toll free: 1 (800) 563-5660
028-0184-05-PIR-Cover-Installation-Guide_A4_EN
www.viconics.com | sales@viconics.com
9
September 2019
Advertisement
