Advertisement
BEFORE YOU BEGIN
Loss of Control
LOSS OF CONTROL
• The designer of any control scheme must consider the potential failure modes of control paths and, for certain critical control
functions, provide a means to achieve a safe state during and after a path failure. Examples of critical control functions are
emergency stop and over travel stop.
• Separate or redundant control paths must be provided for critical control functions.
• System control paths may include communication links. Consideration must be given to the implications of anticipated
transmission delays or failures of the link.
• Each implementation of equipment utilizing communication links must be individually and thoroughly tested for proper operation
before being placed into service.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
California Proposition 65
CALIFORNIA PROPOSITION 65
This product can expose you to chemicals including Lead and Bisphenol A (BPA), which are known to the State of California to
cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Failure to follow these instructions can result in birth defects or other reproductive harm.
Electrostatic Discharge
STATIC SENSITIVE COMPONENTS
Circuit boards and option cards can be damaged by static electricity. Observe the electrostatic precautions below when
handling controller circuit boards or testing components.
Failure to follow these instructions can result in equipment damage.
Observe the following precautions for handling static-sensitive components:
• Keep static-producing material such as plastic, upholstery, and carpeting out of the immediate work area.
• Store static-sensitive components in protective packaging when they are not installed in the drive.
• When handling a static-sensitive component, wear a conductive wrist strap connected to the component or drive through a minimum
of 1 megohm resistance.
• Avoid touching exposed conductors and components leads with skin or clothing.
Installation
INSTALLATION
• The system must be installed correctly by a qualified technician.
• If replacing an existing Room Controller, label wires before removal of Controller.
• Electronic controls are static sensitive devices. Discharge yourself correctly before manipulating and installing Room Controller.
• A short circuit or wrong wiring may permanently damage Room Controller or equipment.
• All Room Controllers are designed for use as operating controls only and are not safety devices. These instruments have
undergone rigorous tests and verification prior to shipping to ensure proper and reliable operation in the field. Whenever a control
failure could lead to personal injury and/or loss of property, it becomes the responsibility of the user/installer/electrical system
designer to incorporate safety devices (such as relays, flow switch, thermal protections, etc.) and/or an alarm system to protect
the entire system against such catastrophic failures. Tampering with the devices or unintended application of the devices will
result in a void of warranty.
• This device must be installed to provide a separation distance of at least 8in (20cm) from all persons and must not be located or
operating in conjunction with any other antenna or transmitter.
• Refer to the Room Controller User Interface Guide for information on how to configure the Room Controller.
Failure to follow these instructions can result in equipment damage.
1
For additional information about anticipated transmission delays or failures of the link, refer to NEMA ICS 1.1 (latest edition), Safety Guidelines
for the Application , Installation, and Maintenance of Solid State Control or its equivalent
Viconics Technologies Inc. | 7262 Marconi Street, Montreal, Quebec, Canada H2R 2Z5 | Tel: (514) 313-8885 | Toll free: 1 (800) 563-5660
028-0184-05-PIR-Cover-Installation-Guide_A4_EN
WARNING
1
WARNING
NOTICE
NOTICE
www.viconics.com | sales@viconics.com
3
September 2019
Advertisement
