Advertisement
CONTENTS
Safety Information .......................................................................................................................... 2
Before You Begin ........................................................................................................................... 3
Overview ........................................................................................................................................ 4
Typical PIR Lens Detection Pattern ................................................................................................ 5
Deployment ................................................................................................................................... 6
Installation ...................................................................................................................................... 8
SAFETY INFORMATION
Important Information
Read these instructions carefully and look at the equipment to become familiar with the device before trying to install, operate,
service or maintain it. The following special messages may appear throughout this bulletin or on the equipment to warn of potential
hazards or to call attention to information that clarifies or simplifies a procedure.
The addition of either symbol to a "Danger" or "Warning" safety label indicates that an electrical hazard exists which will
result in personal injury if the instructions are not followed.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE is used to address practices not related to physical injury. The safety alert symbol shall not be used with this signal
word.
Please Note
Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel. No responsibility is
assumed by Schneider Electric for any consequences arising out of the use of this material.
A qualified person is one who has skills and knowledge related to the construction, installation, and operation of electrical
equipment and has received safety training to recognize and avoid the hazards involved.
Viconics Technologies Inc. | 7262 Marconi Street, Montreal, Quebec, Canada H2R 2Z5 | Tel: (514) 313-8885 | Toll free: 1 (800) 563-5660
028-0184-05-PIR-Cover-Installation-Guide_A4_EN
DANGER
WARNING
CAUTION
NOTICE
www.viconics.com | sales@viconics.com
2
September 2019
Advertisement
