Introduction - Xtralis ICAM ILS-1 Product Manual

Xtralis ICAM

1 Introduction

The Xtralis ICAM ILS-1 system is an aspirating smoke system that utilizes an air-sampling pipe network
to draw air towards one or two high-sensitivity laser point detectors in an aspirated enclosure. The use
of the pipe network allows a larger area of coverage in comparison to traditional point detectors. Three
different operating modes (Single, Redundant and Double-Knock) and three programmable alarm levels
are provided enabling the system to be configured according to application.
A high performance aspirator and flow sensing system ensure a constant, monitored airflow. The
amount of airflow can be displayed on a ten-element bargraph with adjustments for high and low flow
thresholds. All detector configuration can be achieved with the integrated programming keys located on
the side of the device.
The ILS-1 is a standalone system where faults and alarms are reported via separate volt-free contacts.
These contacts may be connected to a monitoring fire alarm control panel.
Important Note: Aspirating Smoke Detectors supplied and installed within the EU from June 2009
must conform to the EU Construction Products Directive (89/106/EEC) and the related European
Standard EN54-20.
This unit has been tested and certified to ensure general conformance to the above directive and
standard but strict adherence to this Product Guide is required to ensure that the installation
meets these requirements in all respects.
www.xtralis.com
Xtralis ICAM ILS-1 Product Guide
1