Xtralis ICAM ILS-1 Product Manual page 17

Xtralis ICAM
A description of ILS-1 functions are shown in the following table.
Function
Reset the unit
Isolate the system
Set fan speed
Set sensitivity of bargraph to
changes in airflow velocity
Select the BARGRAPH LED
segment above which the FLOW
HIGH LED will be illuminated
Select the BARGRAPH LED
segment below which the FLOW
LOW LED will be illuminated
Set FLOW DELAY time of both
channels
Set smoke detector ALERT
alarm threshold
Set smoke detector ACTION
alarm threshold
Set smoke detector FIRE alarm
threshold
Select Detector Mode ('1', '1 OR
2', or '1 AND 2')
Set SOUNDER On or Off
Set/Unset Alarm Latching
function
www.xtralis.com
Table 6-1: User Functions for the ILS-1 System
Display
-
ISOLATE LED flashes when
not set and steadily illuminates
when set
POWER LED flashes.
Bargraph display indicates fan
speed of 0 to 9.
FLOW OK flashes.
Bargraph display indicates
sensitivity (0 = Minimum, 9 =
Maximum).
FLOW HIGH flashes.
FLOW LOW flashes.
FLOW HIGH and FLOW LOW
LEDs both flash
ALERT LED flashes.
ACTION LED flashes.
FIRE LED flashes.
Associated MODE LED flashes.
If it sounds short beeps, this signifies it
is in the Off setting.
If the buzzer sounds long beeps, this
signifies it is On.
SMOKE DETECTOR FAULT
LED flashes.
Bargraph display indicates
alarm latching status (0 = Non
Latching, 1 = Latching).
Xtralis ICAM ILS-1 Product Guide
Special Instructions
To reset the unit, press CHANGE
when the LED is flashing.
-
Please refer to Table 6.3 for more
details.
Please refer to Table 6.3 for more
details.
High flow threshold can be set for
Bargraph values 5 to 9.
Low flow threshold can be set for
Bargraph values 0 to 4.
Please see Section 6.3.2 for
information on flow delays.
Please refer to Table 9-1
Please refer to Table 9-1
Please refer to Table 9-1
See 6.2.1 for detailed description of
Modes.
-
-
11