Detectors - Xtralis ICAM ILS-1 Product Manual

Xtralis ICAM ILS-1 Product Guide Xtralis ICAM

5 Detectors

The ILS-1 is supplied with a single laser point detector as standard with the option for a second detector
(order code: LPDET) for Redundant or Double-Knock operating modes.
The detectors interface directly with the ILS-1 system. This allows the detectors status and analog
smoke level output to be read and interpreted by the ILS-1 processor.
Figure 5-1: Address switches for an ILS-1 system
Each detector is identified with a two-digit address which is set on switches on the underside of the top
detector part. The addresses should be left to the factory pre-set values of 1 for the default detector in
the channel/detector 1 position and address 2 for the optional, second detector in the channel/detector
2 position.
Note: If the detectors are removed for maintenance they must be fitted in the positions described
above - failure to do so may result in false reporting in the event of a fault or fire.
8 www.xtralis.com