BLOTZ B28-WW2-301 Instructions

BLOTZ B28-WW2-301 Instructions

28mm submarine: missile tubes

Advertisement

28mm Submarine: Missile Tubes

B28-WW2-301
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the front and rear main supports plus the
central cross beam and two side supports from
the sprue as shown above.
Attach the side supports into the gaps provided.
Starting from the bottom, glue each strip into
Repeat this on the other side of the model.
place.
Glue the cross beam to the front and rear supports.
Take the side pieces shown above from the sprue.
Then attach the upper strip.
Glue the top plate into position.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B28-WW2-301 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BLOTZ B28-WW2-301

  • Page 1 28mm Submarine: Missile Tubes B28-WW2-301 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
  • Page 2 Each hatch is made from the three pieces shown Glue these together as shown. above. Glue the hatches into position. Finally attach the deck plate. The finished model. Linking the Components The individual components can be attached together using the supplied rectangular link pieces.

Table of Contents