Advertisement
Quick Links
28mm WWII Guard Tower
B28-WW2-101
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
First remove the platform and the four walls from
the sprue, laying them out as shown above.
Remove the six roof supports (shown above) from
the sprue.
Glue the walls to the platform, with the lugs on the
platform slotting into the holes provided in the
walls. Allow to dry.
Glue the roof supports together to form two pieces
(as shown). Leave to dry.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for BLOTZ B28-WW2-101
Summary of Contents for BLOTZ B28-WW2-101
- Page 1 During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while you allow glue to dry. A full-colour copy of these instructions can be found on our website: www.blotz.co.uk First remove the platform and the four walls from Glue the walls to the platform, with the lugs on the the sprue, laying them out as shown above.
- Page 2 Now for a tricky bit. Make sure you are using a Apply a little glue to the points where the ‘Z’ piece flat, level surface and stand the platform on the will meet the legs and then gently put it into two leg pieces shown above.
Need help?
Do you have a question about the B28-WW2-101 and is the answer not in the manual?
Questions and answers