BLOTZ B28-WF-110 Instructions

Asylum Gates & Asylum Gateway
B28-WF-110 / B28-WF-111
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Gateway (Both Kits)
The gateway arch is formed from the pieces shown
Attach the asylum arch and leave to dry.
This will fit snugly within the archway of our
Gettysburg Cemetary Gates building (B28-ACW-001) to
give you an Asylum Gatehouse.
above.
Glue the eyelets into the uprights as shown.
Carefully slide the gates into their eyelets. The
eyelets will fit into the gaps left in the sides of the
gates, then lower the gates so that the pins fit into
the eyelets.