Table of Contents
Advertisement
5.1 Cutter Blades (An overview of Blade types)
Your cutter comes with a selection of blades. The blades are packed in a foam
packing material, in addition to this there is a colored rubber protective cap. The
yellow caps indicate 30
blades. Be careful when handling the blade as the cutting end is very sharp. Blades
are selected for different applications, a guide is shown below:
Name
Image
Blade
Pen
Holder
* Maximum cutting depth is defined by a combination of the material type (Density) and the blade (for label media, papers and card
this is typically 350 microns)
Intec Printing Solutions - Manual for ColorCut LC600 Sheet fed Label Cutter ........................................................................ Page No: 34
red caps indicate a 45
O,
Blade
Angle
Diameter
30
O
45
O
60
O
blade while the blue caps are 60
O
Features and Application
For Film, very soft material, thin
1mm
label material.
Typically for labels, stickers,
1mm
and thin paper/card,
For thick media. Suitable for Mag-
1mm
netic media or dense media like
Metallic vinyl.
Used at setup, to calibrate the offset
between the Optical Registration
Mark sensor (Red light) and the
centre of Tool1 (The blade).
O
Advertisement
Table of Contents
