5.6
Securing the burner to the boiler
Prepare a suitable lifting system using the rings
3)(Fig. 19), after removing the fixing screws 7) of
the casing 8).
Prepare a suitable lifting system using the rings 3)(Fig. 191)
of the head assembly.
Check the correct positioning of the insulating gasket 6
6)(Fig. 18); the black side must be faced the burner flange
and the white one to the boiler side.
Insert the head assembly on the previously prepared boiler
hole (Fig. 19) and fix with the M18 screws.
Remove the rings 3) from the head assembly 1).
Lift the burner by means of the rings 3)(Fig. 19) after having
removed the cover 8) fixing screws 7)(Fig. 20).
Fix the burner onto the head assembly with the supplied
screws 5)(Fig. 19).
The seal between burner and boiler must be
airtight.
ATTENTION
20129398
20152087
6
8
7
20122782
Installation
3
Fig. 18
3
3
24
GB
1
3
5
3
3
20122779
4
A
B
Fig. 19
Fig. 20