Christie Q Series Installation And Setup Manual page 14

c) To center the lens, press the Right arrow.
To center the lens in standby mode, on the control panel, press FUNCTION and LENS SHIFT
at the same time for three seconds.
2. Turn off and unplug the projector.
3. Allow the projector to sufficiently cool down.
4. Remove the front cover:
a) Slide the upper part of the front cover upward while pressing the front cover from the
underside and remove from the projector.
b) Slide the lower part of the front cover downward while pressing the front cover from the
upperside and remove from the projector.
5. To remove the lens:
a) Support the lens.
b) Lower the lens lock lever to the lowest position.
You can move the lever while the upper plate touches the lower one.
c) Remove the lens from the projector.
To avoid any malfunctions, ensure the surface of the lens does not come in contact with
the projector.
Optional Lenses Q Series Installation and Setup Manual
020-102550-01 Rev. 1 (04-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Installing the ultra short throw fixed lens
Front cover
(upper part)
Front cover
(lower part)
14