Christie Q Series Installation And Setup Manual page 12

The balance of focus at the peripheral part of the projected image changes when installing the
lens in the projector and projecting on a screen. How to perform the tilt correction differs
depending on whether the installation on the table or ceiling mount.
Perform the tilt correction before installing the lens in the projector as a malfunction can occur
if performed with the lens installed.
• For installation on the table, move the tilt correction lever in the direction of (+).
• For installation on the ceiling, move the tilt correction lever in the direction of (-).
4. Install the lens:
a) Remove the protection sheet pasted to the projection window and the lens cap from the
lens.
Failing to remove the protection sheet may cause it to melt.
Protection shee t
b) Support the lens and move the lens lock lever upward until the lever clicks into the locked
position.
Optional Lenses Q Series Installation and Setup Manual
020-102550-01 Rev. 1 (04-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Tilt correction lever
T
-
+
T
-
+
Lens cap
Projection window
Installing the ultra short throw fixed lens
T
12