Electrical Connection; Safety Instructions For Electrical Connection - Siemens SINAMICS GL150 Operating Instructions & Installation Instructions

Electrical connection

Note
Control and signal lines must always be connected according to the circuit diagrams supplied
with the unit. Detailed information about connecting the components is given in the
interconnection diagram.
6.1

Safety instructions for electrical connection

When carrying out any work, carefully observe the information provided in Chapter "Safety
instructions (Page 15)".
Danger due to incorrectly sealed cable entry
If the cable entry is not correctly sealed, it is possible that the device no longer complies with
the requirements associated with the specified degree of protection.
Operation with an insufficient degree of protection can result in death, serious injury and
material damage.
● To maintain the degree of protection, after connecting the cable, immediately seal the cable
Danger caused by changing the floor panel or the roof panel
If you make any changes to the floor panel or the roof panel in order to modify the cable entry,
the changes may mean that the requirements related to the specified degree of protection are
no longer complied with. If there are any holes in the floor or roof panel, then animals and
vermin, for example, can get into the device while it is operational.
When operated with an insufficient degree of protection, this can result in death, serious injury
and material damage.
● To maintain the degree of protection, after installation, immediately seal the holes so they
SINAMICS GL150 6SL38503UM114PA0Z
Operating Instructions Rev.201910301420 MUSTER
entries so they are air-tight.
are air-tight.
6
75