Leica M10-R Instruction Manual page 128

EN
The display switches off after the picture is taken/
the LCD panel goes dark after the picture is taken
Flash won't fire
The flash does not fully illuminate the object
No continuous recording available
The image on the LCD panel displays lots of noise
Image storage takes a long time
Electronic viewfinder is dark
Review and image management
Selected images cannot be deleted
File numbering does not start at 1
The time and date settings are incorrect or are not
displayed
The time and date stamp on images are incorrect
The time and date stamp on images are unwanted Setting was ignored
Lens information is not displayed
Pictures/recordings are damaged or missing
128
Flash loads after picture is taken, LCD panel deactivates
during load time
The flash cannot be used with the current settings
Battery is depleted
Pressing the shutter button while flash is still loading
Automatic bracketing or Picture series is activated
Object is outside the flash range
Flash is covered
The camera is overheated and the function was
temporarily disabled to protect the camera
Light enhancement function of the LCD panel in dark
surroundings
The memory card inserted is slow
Switchover between EVF and LCD incorrectly set
Some of the selected images are write protected
The memory card contains previously stored images
The camera has not been in use for an extended period
of time (the battery was removed)
Time settings are incorrect
is deactivated
Lens Detection Lens Detection
The attached lens is not encoded
The memory card was removed while the readiness
indicator was flashing
The memory card formatting is faulty or the card is
damaged
Wait until the flash is loaded
Refer to the list of flash function-compatible settings
Charge or replace the battery
Wait until the flash is loaded
Change the setting
Move object into flash range
Make sure the th flash unit is not covered by your finger
or some object
Allow camera to cool down
Not a fault – picture quality will not be impacted
Use a suitable memory card
Select a suitable setting
Remove write protection (using the device with which
the file was originally set to write protected)
See section "Data Management"
Insert a charged battery and configure the correct
settings
Set the time correctly
Caution: Time settings will be lost if the camera is not
used/remains in storage with a depleted battery over
an extended period of time
Cannot be removed in retrospect
Deactivate the function as needed
Change the setting
Contact Leica Customer Care
Never remove the memory card while the readiness
indicator is flashing. Charge the battery.
Reformat the memory card
(Caution: Loss of data!)