Leica M10-R Instruction Manual page 127

The LCD panel is to dark or too bright/not clear
menu does not appear
Favorites Favorites
Live View stops suddenly or doesn't start
The brightness in Live View mode is not the same
as in the pictures
The number of remaining exposures does not
count down after a picture is taken
Recording
The camera won't take a picture/shutter button is
deactivated
Image noise appears on the LCD panel/in the
viewfinder when the shutter button is pressed to
the first pressure point
LCD panel/viewfinder deactivates after a very
short time
The brightness setting is incorrect
Viewing angle is too small
Brightness sensor blocked
The favorites menu is empty
The camera is hot due to high ambient temperature,
extended Live View operation, extended video recording
or serial exposures
The brightness settings for the LCD panel have no
influence over the exposures
Exposure Simulation is deactivated
The exposure requires only very little memory space
Memory card is full
The memory card is not formated
The memory card is write protected
Dirt on the memory card contacts
The memory card is damaged
The sensor is overheating
The camera has switched off automatically
( )
Auto Power Saving Auto Power Saving
Picture data is being written to the memory card and the
cache is full
Noise reduction function is working (e.g. after night
photography with long exposure times)
Battery is depleted
Camera is processing a picture
Image numbering has reached its limit.
The gain is increased to aid image composition if the
object is insufficiently lit with reduced aperture opening
Power Save settings are activated
Adjust the display brightness
View it at a perpendicular angle
Make sure that the brightness sensor is not blocked
Add at least one function
Allow camera to cool down
Adjust the brightness settings as needed
Activate the function
This is not a fault; the number of remaining exposures
is calculated as approximations
Replace the memory card
Reformat the memory card (Caution: Loss of data!)
Deactivate the write protection on the memory card
(small lever on the side of the memory card)
Clean the contacts with a soft cotton or linen cloth
Replace the memory card
Allow camera to cool down
Switch the camera on again
deactivate auto shutdown as needed
Wait
Wait or deactivate noise reduction
Charge or replace the battery
Wait
See section "Data Management"
Not a fault – picture quality will not be impacted
Change the settings as needed
EN
127