TESTit
Preparing the measuring gauge
2.
Place one of the flat plug gauges on the mounting point
that was left free at delivery.
3.
Screw in the mounting screw and tighten to a tighten-
ing torque of 0.8 Nm.
4.
Loosen and remove the mounting screw [1] of the plug
gauge that is [2] still mounted on the opposite side.
5.
Likewise fit on a flat plug gauge [4] in its place as well.
Screw in the associated mounting screw [3] and tighten
to a tightening torque of 0.8 Nm.
INFORMATION
After changeover, the number of clamping posi-
tions must be set in the software, see »Set-
tings«.
Order hotline +49 7144.907-333
33