Hainbuch TESTit Operation Manual page 23

TESTit
Structure and function
module [electronics], that can be separated from each oth-
er.
The clamping device is equipped for location of the meas-
uring gauge.
The measuring gauge is clamped with the clamping device.
The measuring head determines the radial clamping force
via sensors and transmits this data from the TEST module
to the IT module.
The software is designed so that it can be used, not only
with the TEST module in conjunction with the IT module,
but also in conjunction with the »old« TESTit V1.
TESTit V1 devices must be taught-in and thus made known
to the software.
TESTit V2 devices [TEST module and IT module] just have
to be within radio range to connect.
Via Bluetooth Low Energy [BLE] the measured values are
transmitted to the output device with the installed measur-
ing software.
The measurement can be performed stationary, as well as
at rotational speed.
Order hotline +49 7144.907-333 23