Electrical Specifications; Rtc Battery - Seco SBC-C23 User Manual

2.3 Electrical specifications

SBC-C23 needs to be supplied only with an external 12V
C23 power consumption by itself is around 5W, more power is required for the possible attached devices).
This voltage can be supplied through a standard 6.3mm (internal pin, diameter 2.0 mm) Power Jack. Internal pin is V
power line. DC mating plug diameter 5.5mmm, internal hole 2.1
Power In Connector CN76
Pin Signal
1 +12V
IN
2 GND
The board can also be supplied by an optional 3.7V 2200mAh rechargeable battery (factory option), which can be an EEMB LIR18650 or a cabled RRC 100587 battery pack (3.6V
2200 mAh) with NTC reading.
2.3.1

RTC Battery

The SBC-C23 board can be equipped with an optional low-power Real Time Clock embedded on the module (which is a NXP PCF2123).
If the board is not equipped with the optional rechargeable battery, then it will be available a soldered horizontal 3V coin cell lithium battery to supply the RTC.
The battery used is a not-rechargeable CR1225 Lithium coin-cell battery, with a nominal capacity of 48mAh.
In case of exhaustion, the battery should only be replaced with devices of the same type. Always check the orientation before inserting and make sure that they are
aligned correctly and are not damaged or leaking.
Never allow the batteries to become short-circuited during handling.
CAUTION: handling batteries incorrectly or replacing with not-approved devices may present a risk of fire or explosion.
Batteries supplied with SBC-C23 are compliant to requirements of European Directive 2006/66/EC regarding batteries and accumulators. When putting out of order
SBC-C23, remove the batteries from the board in order to collect and dispose them according to the requirement of the same European Directive above mentioned.
Even when replacing the batteries, the disposal has to be made according to these requirements.
SBC-C23
SBC-C23 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.1 - Author: S.B. - Reviewed by L.B. -Copyright © 2020 SECO S.p.A.
± 10% power supply, with a minimal 20W power rating (SBC-
DC
As an alternative, +12V can also be supplied using dedicated PCB Terminal block
DC
CN76, which is a Phoenix Connector p/n MC 1,5/ 2-GF-3,81.
Please check Phoenix
needed.
IN
15