Table of Contents
Advertisement
DIMM Installation Procedures
The DIMM slot has two keys marked
"VOLT" and "DRAM", thus making the
module only fit in one direction. Note that
the module must be a 2.5 V unbuffered
DIMM.
Step 1: Insert the module vertically into
the DIMM socket, and then
push it in.
Step 2: The plastic clip at the side of the DIMM socket will automatically close.
3.3. AGP Display Adapter Installation
The AGP slot on WinFast K7NCR18 series supports only 1.5 V 4x/8x AGP device.
To install an AGP display adapter, follow these steps:
Step 1: Push the clip at the end of AGP slot.
Step 2: Position the AGP card over the AGP slot. Do
not tilt the card. Insert the bus connector in the
slot and gently press the bus connector down.
Step 3: Push the clip back to close it
3.4. Connecting Instructions
How each connector is connected and what it does is
described here in detail. See Chapter 2 to locate
connectors.
Case Signal Connectors (FP1 & FP2)
FP1:
Pins [1&3] IDE-LED: IDE hard disk LED shows the
activity of a hard disk drive.
.
Step 2
Step 1
Step 3
7
Advertisement
Table of Contents
Need help?
Do you have a question about the WinFast K7NCR18 Series and is the answer not in the manual?