Epson EPL-N2000 Service Manual page 53

EPL-N2000 Service Manual
1. When "aaaa" is LC1 or LC2:
2.
Measure
Toner is nearly out, which may cause print quality to deteriorate. If the you
Staus
press the button, the printer outputs another sheet, but afterward the same
message returns on the panel.
On Line
LED
Continue
Form Feed
1.
Measure
2.
[SelecType: Size Ignore = OFF]
Staus
Paper loaded in paper source "aaaa" does not match the selected page size.
On Line
LED
Continue
Form Feed
[SelecType: Auto Cont = OFF in the Config menu]
The error is cleared with either of the following methods:
1.
2.
Measure
[SelecType: Auto Cont = ON in the Config menu]
The error is automatically cleared without replacing paper after a set
period of time. Then the printer resumes feeding paper from the "aaaa"
paper source. In this case, when there is data for 2 pages or more, the printer
indicates the same error message before each page.
Rev. A
Table 1-21. Error Messages (Continued)
Error Messages and Descriptions
Paper Out aaaaa bbbbb*
The error is cleared by inserting the "bbbb" size paper into cassette
"aaaa".
When "aaaa" is MP:
The error is cleared by inserting the "bbbb" size paper in MP tray.
If the warning error "Check Paper Size" does not appear after printing,
it means that the Paper Size for MP tray in the SelecType menu has
been changed automatically to "bbbb."
Toner Out
OFF
OFF
Keeps the same status as before.
Replace the toner cartridge with a new one.
Press the Continue button for a temporary recovery.
Paper Set aaaa bbbb
OFF:
ON:
Flashing
Keeps the same status as before.
Press the Continue button after inserting the "bbbb"size paper into the
"aaaa" paper source. Then the printer starts feeding "bbbb" size paper
from the "aaaa" paper source.
Press the Continue button without replacing the paper. If there is more
than 2 pages of data remaining, the printer discontinues the job after
printing 1 page and the same error occurs.
1
Size Ignore = OFF
Size Ignore = ON
Product Description
1-41