Epson EPL-N2000 Service Manual page 52

Product Description
The printer has received data when Manual Feed is set to ON through the
Status
SelecType mode or a command.
On Line
LED
Continue
Form Feed
This error can be cleared using any of the following methods:
1.
Measure
2.
3.
This error can be caused by any of the problems listed below:
1.
2.
Status
3.
*1: The actual display for "bbbb" is the paper size selected using SelecType
*2: The actual display for "aaaa" is the paper source from which paper is
On Line
LED
Continue
Form Feed
1-40
Table 1-21. Error Messages (Continued)
Error Messages and Descriptions
Manual Feed
OFF
Flashing
Keeps the same status as before
Press the On Line button after placing "bbbb"size paper in the MP tray.
Note that the Check Paper Size error does not occur, regardless of
whether Size Ignore = ON in the Config menu. A Paper Out error does
not occur despite paper empty condition in the MP Tray.
Press the Continue button. In this case, the printer starts printing after the
paper source is selected, ignoring Manual Feed = ON.
A Paper Out or Check Paper Size occurs when there is no paper in the
selected paper source or the size of paper in the selected paper source
does not match the size specified.
Perform a reset or warm boot.
Paper Out aaaaa bbbbb*
There is no paper loaded in the paper source indicated by "aaaaa"*
No paper is loaded in any paper source. [SelecType: Manual Feed = OFF]
The actual message for "aaaa" is the paper source from which paper
was fed in the previous printing.
"LC1" is displayed instead if no paper is detected in any paper source
when the printer is turned on.
There is no paper in "aaaa"*
canceled by pressing the Continue button when printing is started.
mode or the printer driver.
specified to be fed.
MP = Multipurpose tray
LC1 = Lower paper cassette
LC2 = Optional lower paper cassette
OFF
OFF
Keeps the same status as before.
EPL-N2000 Service Manual
bbbb
1
2
when Manual Feed = ON has been
2
Rev. A