Osd Menu Mode; Lcd Functionality In Ready Mode - Barco FS-FL40 MKII Series User Manual

Getting to know the projector.
Image 3–7 Notifications page
Image 3–8 Preview page
Mirroring the source input. (Preview page).
This page in the information mode is useful for verifying the input signal connection without switching the
projector (light source on).
This function shows the output of the currently active source on the LCD panel. The source content should be
a picture without warp and blend applied. The picture will be limited by the LCD resolution, 800x480pixels.
The projector performance will drop when the LCD monitoring the input, due to use of resources.
Exit the input monitoring when not in use.

3.4.4 OSD Menu mode

About.
This is the projector setup menus, explained in detail in their own chapters in this manual. (Source menu,
Image menu, Installation menu, System Settings menu, Status menu).

3.4.5 LCD functionality in Ready Mode

When the projector is in Ready mode, it is possible to activate and navigate in the projectors menu on the LCD
display, in order to set or check values and settings before the lamp is switched on.
Ready mode is enabled either when the power cable is connected (after the startup sequence), or when
pressing the Power Off for 4 seconds when the projector is in On mode. See chapter 5.4 Power Mode
Transitions for a graphic presentation of the ready mode.
24 R5913251 /00 FS-FL40 MKII series