Table of Contents
Advertisement
5.4.5 Going from READY to ECO standby
Description
If ECO Standby mode is enabled in the service menu (refer to the section "GUI - system settings/Standby
ECO", in User Guide) the projector will automatically go to ECO standby mode after a time-out (default 15
minutes). All electronics (including fans, pumps,...) go down except for a very small wake up controller. The
Power on/off button will FLASH WHITE every second.
5.4.6 Going from ECO to ON
Description
Press the Power on/off button on the projector, or the Power On button on the remote control. The projector
goes from ECO directly to ON. The projector will go through the same booting phase as on power plugging,
then do the transition from READY to ON. Of course startup-time will be longer then from READY to ON.
5.4.7 Wake On LAN (WOL)
About
The projector has WOL functionality, that can be used for the projector to go from ECO mode to READY
mode. Use a json command for transition from READY to ON.
The WOL is performed by sending a Magic Packet followed by the projectors MAC address. The MAC
address is found in the Menu / Settings / Communication / LAN. menu. The MAC address is similar to the HW
address that is shown in this menu path.
The LAN cable must be connected when the projector enter the ECO mode, in order to obtain the
Wake on LAN function.
5.5 Power modes
General
The table below details the projector power modes.
Mode
Normal
Ready
ECO Standby
5.6 Customize projector settings
About
The projector display, behavior and user interface can be adjusted to meet individual requirements.
Options include:Menu/Settings/Themes
•
Adjust the OSD menu color
Getting the projector started
Description
Projector is booted up and the light source is on
Projector is booted up but the light source is off
Light source is switched off and projector electronics
are powered down
R5913251 /00
FS-FL40 MKII series
45
Advertisement
Table of Contents
