Table of Contents
Advertisement
The HEPA Filter is located on the right end of the main
body and filters the noxious fumes to provide a better
working environment.
The HEPA Filter is 18" x 20" x 5.9" (457 x 508 x
150mm) and rated at 99.99% efficiency of 0.3-micron
particle.
IMPORTANT: Always verify that the
direction of "Air Flow Arrow" on the filter matches the
actual direction of air flow of the system. Failure to
match the air flow will damage the filters and possibly
the systems motor.
This down draft table uses one Aluminum filter screen
to catch and screen sparks and steel chips.
This is a single screen that measures 11.2" x 24.8" x
.86" (285 x 630 x 22 mm).
This aluminum filter is washable and reusable,
however it will need to be replaced when worn,
damaged, or when it becomes so clogged that
washing is no longer effective.
4. Disconnect the down draft table from the power
supply.
5. Replace the Aluminum filter by lifting slightly on the
filter and pulling outward on the bottom and then
lowering the filter out of the frame.
6. Install a cleaned or new filter in reverse order.
28
28
Advertisement
Table of Contents
