Table of Contents
Advertisement
• WORKING CLEARANCES: Take into consideration space around this machine to provide
the air flow needed to allow for proper filtration. This unit will work best if it is located away
from corners, and heating/cooling vents.
• It is important to maintain free area around the machine, which is required for the working
place.
• LEVELING: The machine should be sited on a level, concrete floor. Provisions for securing it
should be in position prior to placing the machine.
• FLOOR: This tool distributes a large amount of weight over a small area. Make certain that
the floor is capable of supporting the weight of the machine, work stock, and the operator.
The floor should also be a level surface. If the unit wobbles or rocks once in place, be sure to
eliminate by using shims.
• POWER SUPPLY PLACEMENT: The power supply should be located close enough to the
machine so that the power cord is not in an area where it would cause a tripping hazard. Be
sure to observe all electrical codes if installing new circuits and/or outlets.
12
12
Advertisement
Table of Contents
