Transport And Storage; Operation - Trotec TA400 Operating Manual

Transport and storage

Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device, use the transport case included in
the scope of delivery in order to protect the device from external
influences.
Before transporting the device, please observe the following:
• Remove the hoses from the connections at device and
Pitot tube.
Storage
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• protected from dust and direct sunlight
• For storing the device, use the transport case included in
the scope of delivery in order to protect the device from
external influences.
• The storage temperature is the same as the range given in
the Technical data chapter.
• Remove the battery from the device.
6

Operation

Inserting the battery
Note
Make sure that the surface of the device is dry and the
device is switched off.
1. Open the battery compartment at the rear of the device by
sliding the battery compartment cover (4) down at the
arrow mark.
2. Use the battery clip to connect the 9 V battery with correct
polarity.
3. Place the battery with the battery clip into the battery
compartment.
4. Slide the battery compartment cover (4) back on the
battery compartment.
ð The cover should click into place.
Switching the device on
Info
Please note that moving from a cold area to a warm
area can lead to condensation forming on the device's
circuit board. This physical and unavoidable effect can
falsify the measurement. In this case, the display
shows either no measured values or they are incorrect.
Wait a few minutes until the device has become
adjusted to the changed conditions before carrying out
a measurement.
1. Press the Power button (10).
ð The device is switched on.
dynamic pressure anemometer TA400 EN