Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Trotec T660
Summary of Contents for Trotec T660
- Page 1 T660 OPERATING MANUAL MATERIAL MOISTURE MEASURING DEVICE...
-
Page 2: Table Of Contents
Further, ® TROTEC accepts no liability whatsoever for possible mistakes or damage which have been caused by utilising the determined ® measured results. © TROTEC Operating manual – Material moisture measuring device T660... -
Page 3: Information About The Device
Cross control Information about the device Description of the device The material moisture measuring device T660 is a dielectric humidity sensor, which can be used for the quick and non-destructive localization of humidity or moisture distributions. The device enables the detection of near-surface moisture in walls or flooring. -
Page 4: Technical Data
• Observe the storage and operating conditions (see chapter Technical data). Intended use Only use the material moisture measuring device T660 for the moisture measurement of building materials. Here, read and observe the technical data. To use the device for its intended use, only connect and use accessories and spare parts which have been approved by ®... -
Page 5: Transport And Storage
1. Open the cover of the battery compartment (3). 2. Insert the batteries in the compartment as indicated in the figure. 3. Close the cover of the battery compartment (3). – The device can now be switched on. Operating manual – Material moisture measuring device T660... - Page 6 2. Firmly place the measuring head in a vertical position on the good to be measured. 3. Observe a minimum distance of 8 to 10 cm to corners. 4. Read the measured value from the display. Operating manual – Material moisture measuring device T660...
- Page 7 3. Select the desired value by use of the Up (7) or Down (9) key. 4. Press the OK button (10) for approx. 2 seconds. – The set value will be adopted. – The device switches to measuring mode. Operating manual – Material moisture measuring device T660...
- Page 8 – All measured values are then determined anew based on – The offset is set. the measurement proceeding in the background. – The device switches to measuring mode. – With set offset value the indication CAL (17) continues to be displayed. Operating manual – Material moisture measuring device T660...
-
Page 9: Measuring Principle
• If the material to be measured contains metal (e.g. nails, screws, lines, pipes, etc.) and is situated within the sensor's measuring field, the measured value skyrockets. In that event the measurement is not conclusive. Operating manual – Material moisture measuring device T660... -
Page 10: Pc Software
For building materials the measurement results of the dielectric measuring method can only be used as reference for a rough ori- entation. Display [digit] Building moisture zone < 40 digits 40 - 80 digits damp > 80 digits Operating manual – Material moisture measuring device T660... -
Page 11: Errors And Faults
1. Download the current PC software from the Internet. To do The accurate functionality of the device was tested during pro- so, visit the website www.trotec.de. First click on Service, duction a number of times. However, if functionality faults do followed by Downloads and then Software. -
Page 12: Disposal
Directive Herewith, we declare that the T660 material moisture measuring 2002/96/EC of the European Parliament and Council of device was developed, constructed and produced in compliance 27th January 2003 concerning old electrical and electronic with the named EC directives. - Page 13 TROTEC GmbH & Co. KG Grebbener Str. 7 52525 Heinsberg Deutschland +49 2452 962-0 +49 2452 962-200 info@trotec.com www.trotec.com...