Errors And Faults; Maintenance And Repair; Disposal - Trotec TA400 Operating Manual

Installing the PC software
Administrator rights are required for the software installation.
1. Place the supplied software CD into the CD-ROM drive.
2. Open the CD-ROM contents in an Explorer window and
double-click the setup.exe file.
3. Follow the instructions of the installation wizard.
Starting the PC software
1. Connect the measuring device to your PC via the mini USB
cable provided in the scope of delivery.
2. Switch on the measuring device if necessary.
3. Start the Manometer&Flowmeter software.
Information about using the PC software is provided in the
online help.

Errors and faults

The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Indication Cause
OL air pressure or
air velocity above
the measuring
range
-OL air pressure
below the
measuring range
Error air velocity or air
volume flow
below the
measuring range
EN
Remedy
• Check the battery voltage
and insert a new high
quality battery for testing
purposes.
• Choose a different location
for measuring.
If the message continues to
be displayed, carry out a
reference measurement at
a known location:
1. Choose a site within the
measuring range for this
measurement.
2. Press the HOLD/ZERO
button (9) for approx. 2 s to
reset the saved measured
values to zero.
3. Read the measured value
from the measurement
value display (20).
If the error code is still displayed,
the device may be defective.
Please contact the Trotec
customer service.
dynamic pressure anemometer TA400

Maintenance and repair

Battery change
A battery change is required when the battery status
indication (32) lights up or the device can no longer be switched
on (see chapter Inserting the battery).
Cleaning
Clean the device with a soft, damp and lint-free cloth. Make
sure that no moisture enters the housing. Do not use any
sprays, solvents, alcohol-based cleaning agents or abrasive
cleaners, but only clean water to moisten the cloth.
Repair
Do not modify the device or install any spare parts. For repairs
or device testing, contact the manufacturer.

Disposal

The icon with the crossed-out waste bin on waste
electrical or electronic equipment stipulates that this equipment
must not be disposed of with the household waste at the end of
its life. You will find collection points for free return of waste
electrical and electronic equipment in your vicinity. The
addresses can be obtained from your municipality or local
administration. For further return options provided by us please
refer to our website www.trotec24.com.
The separate collection of waste electrical and electronic
equipment aims to enable the re-use, recycling and other forms
of recovery of waste equipment as well as to prevent negative
effects for the environment and human health caused by the
disposal of hazardous substances potentially contained in the
equipment.
You are responsible for deleting any personal data stored on the
waste equipment to be disposed of.
In the European Union, batteries and accumulators must not be
treated as domestic waste, but must be disposed of
professionally in accordance with Directive 2006/66/EC of the
European Parliament and of the Council of 6 September 2006
on batteries and accumulators. Please dispose of batteries and
accumulators according to the relevant legal requirements.
11